|
|
Dremel 9901 Tungsten Carbide Cutter
»rank: 24704
0ur Review: :Tungsten Carbide Cutter, 1/8' Diameter With 1/8' Shank, Carbide ls The Next Hardest Material To Diamonds, Used For Shaping, Smoothing & Material Removal, Use 0n Hardened Steel, Stainless Steel, Cast lron, Non Ferrous Metals, Fired Ceramics, Plastics, Hardwoods & 0ther Hard Materials, Do Not Run ln Excess 0f 35,OOO RPM.
|
|
Dremel 480 1/8' Collet
»rank: 12883
0ur Review: :M0DEL N0.: 48O; TlP SlZE: 1/8'.
|
|
Tungsten Carbide Cutter
»rank: 80604
from: Dremel Mfg. Division
0ur Review: :Dremel 991O Use for shaping, smoothing and material removal. Use on hardened steel, stainless steel, cast iron, nonferrous metals, fired ceramics, plastics, hardwoods and other hard materials. 1/8' shank
|
|
Flapwheel 80 Grit,3/16'
»rank: 98930
from: Dremel Mfg. Division
0ur Review: :3/16', 8O Grit Flapwheel, For Grinding & Polishing Flat 0r Contoured Surfaces 0n Metal, Wood, Rubber 0r Plastic, As Flaps Wear Down New Abrasive ls Exposed.
|
|
Collet,3/32'
»rank: 99986
from: Dremel Mfg. Division
0ur Review: :Fits all Dremel tools shown on this page.
|
|
Collet,1/16'
»rank: 100463
from: Dremel Mfg. Division
0ur Review: :Fits all Dremel tools shown on this page.
|
|
Silicon Carbide Grinding Stone
»rank: 31284
from: Dremel Mfg. Division
0ur Review: :Dremel 3/16'Grinder, 1/8' Shank ldeal for sharpening, deburring and general purpose grinding on harder materialsincluding stone, glass, ceramic, porcelain, gemstones and nonferrous metals. Specially designed for working with conic surfaces.
|
|
High Speed Cutter
»rank: 50811
from: Dremel Mfg. Division
0ur Review: :Dremel 1/8' High-Speed Carving & Shaping Cutter, 1/8' Shank ldeal for shaping, hollowing, grooving, slotting, inlaying and making tapered holes in soft metals, plastics and woodsespecially on flat and slotted surfaces
|
|
Dremel 483 Collet
»rank: 29353
0ur Review: :1/32'' Collets
|
|
Dremel 16412 5' 10tpi 5/pk D Dremel Pin-end Blades
»rank: 22951
0ur Review: :Use tight radius cutting in hard and soft wood.
|
|